Subaru 2009 IMPREZA Service Manual page 1900

AUTOMATIC TRANSMISSION
10.Transmission Mounting
System
A: REMOVAL
1. PITCHING STOPPER
1) Disconnect the ground cable from battery.
2) Remove the air intake chamber and intake boot.
(Non-turbo model) <Ref. to IN(H4SO)-7, REMOV-
AL, Air Intake Chamber.>
3) Remove the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-13, REMOVAL, Intercool-
er.>
4) Remove the pitching stopper.
2. TRANSMISSION REAR CROSSMEMBER
AND REAR CUSHION RUBBER
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the front, center and rear exhaust pipes
and the muffler. (Non-turbo model)
<Ref. to EX(H4SO)-6, REMOVAL, Front Exhaust
Pipe.> <Ref. to EX(H4SO)-9, REMOVAL, Center
Exhaust Pipe.> <Ref. to EX(H4SO)-10, REMOV-
AL, Rear Exhaust Pipe.> <Ref. to EX(H4SO)-12,
REMOVAL, Muffler.>
4) Remove the center and rear exhaust pipes and
the muffler. (Turbo model) <Ref. to EX(H4DOTC)-
8, REMOVAL, Center Exhaust Pipe.> <Ref. to
EX(H4DOTC)-13, REMOVAL,
Pipe.> <Ref. to EX(H4DOTC)-15, REMOVAL, Muf-
fler.>
5) Remove the heat shield cover.
Transmission Mounting System
AT-04520
Rear Exhaust
AT-04522
4AT-44
6) Set the transmission jack under transmission.
NOTE:
Make sure that the support plate of transmission
jack does not touch the oil pan.
7) Remove the transmission rear crossmember.
8) Remove the rear cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
T2
2) Install the air intake chamber and intake boot.
(Non-turbo model) <Ref. to IN(H4SO)-7, INSTAL-
LATION, Air Intake Chamber.>
3) Install the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-13, INSTALLATION, Inter-
cooler.>
AT-03697
T1
AT-04524