Subaru 2009 IMPREZA Service Manual page 1915

Hide thumbs Also See for 2009 IMPREZA:

B: INSTALLATION

1) Check the control valve body for dust and other

foreign matter.

2) Temporarily attach the control valve body to the

transmission.

3) Install the oil cooler pipe.

Tightening torque:

8 N·m (0.8 kgf-m, 5.9 ft-lb)

4) Tighten the bolts equally.

Tightening torque:

8 N·m (0.8 kgf-m, 5.9 ft-lb)

(A) Transmission ground

Bolt length mm (in)

(1) 35 (1.38)

(2) 30 (1.18)

5) Connect the control valve connector.

Control Valve Body

AUTOMATIC TRANSMISSION

6) Attach the magnet at the specified position of the

7) Apply proper amount of liquid gasket to the en-

tire oil pan mating surface.

Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020)

or equivalent

8) Fill the 3 holes aside from the bolt holes in the

transmission case, with liquid gasket.

Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020)

or equivalent

9) Install the oil pan by equally tightening the bolts.

Tightening torque:

5 N·m (0.5 kgf-m, 3.7 ft-lb)

10) Fill ATF from the oil charge pipe. <Ref. to 4AT-

27, Automatic Transmission Fluid.>

11) Bleed the air of control valve. <Ref. to 4AT-61,

PROCEDURE, Air Bleeding of Control Valve.>

12) Check the ATF level. <Ref. to 4AT-27, IN-

SPECTION, Automatic Transmission Fluid.>