Subaru 2009 IMPREZA Service Manual page 1898

Hide thumbs Also See for 2009 IMPREZA:

AUTOMATIC TRANSMISSION

22) Attach the ST to side retainer.

ST 28399SA010 OIL SEAL PROTECTOR

23) Align and insert the spline of the front drive

shaft to the splines of the differential bevel gear,

and remove the ST.

ST 28399SA010 OIL SEAL PROTECTOR

24) Insert the front drive shaft into the transmission

securely by pressing the front housing from the out-

25) Install the ball joint into the front housing.

26) Tighten the attachment bolts.

Tightening torque:

50 N·m (5.1 kgf-m, 36.9 ft-lb)

(A) Front arm

(B) Ball joint

Automatic Transmission Assembly

27) Attach the stabilizer link to the front arm.

Tightening torque:

45 N·m (4.6 kgf-m, 33.2 ft-lb)

28) Install the shift select cable onto the select le-

ver. <Ref. to CS-26, INSTALLATION, Select Ca-

29) Install the oil charge pipe, and connect the ATF

cooler hoses to the pipe.

30) Install the propeller shaft. <Ref. to DS-11, IN-

STALLATION, Propeller Shaft.>

31) Install the heat shield cover.

32) Install the rear exhaust pipe and muffler as-

• Non-turbo model

<Ref. to EX(H4SO)-10, INSTALLATION, Rear Ex-

haust Pipe.> <Ref. to EX(H4SO)-12, INSTALLA-

TION, Muffler.>

• Turbo model

<Ref. to EX(H4DOTC)-13, INSTALLATION, Rear

Exhaust Pipe.> <Ref. to EX(H4DOTC)-15, IN-

STALLATION, Muffler.>