Subaru 2009 IMPREZA Service Manual page 2170

C: DISASSEMBLY
NOTE:
The illustration below is suitable for every model.
Perform the same procedures for the other models.
1) Remove the boots and push rod assembly.
2) Apply compressed air through clutch hose at-
taching port.
NOTE:
Face the piston port down and place a piece of
wood underneath to prevent the piston from pop-
ping out.
3) Separate the piston and piston spring.
Operating Cylinder
D: ASSEMBLY
NOTE:
• The illustration below is suitable for every model.
Perform the same procedures for the other models.
• During assembly, apply hydraulic oil to all parts.
Recommended clutch fluid:
New FMVSS No. 116 DOT3 or DOT4 brake flu-
id
1) Install the piston spring onto the piston.
CL-00457
2) Insert piston into the operating cylinder.
3) Install push rod to the boot.
4) Install boot and push rod to the operating cylin-
der.
CL-00458
E: INSPECTION
1) Check the operating cylinder for damage. If op-
erating cylinder is damaged, replace it.
2) Check the operating cylinder for fluid leakage or
damage on the boot. If any leakage or damage is
found, replace the operating cylinder.
CL-00459
CL-17
CLUTCH SYSTEM
CL-00459
CL-00457