Subaru 2009 IMPREZA Service Manual page 2186

FRONT SUSPENSION
(1) Front crossmember
(2) Housing
(3) Ball joint
(4) Front arm
(5) Support plate
(6) Rear bushing
(7) Front bushing
(8) Stud bolt
(9) Stabilizer link
(10) Bracket
(11) Bushing
(12) Stabilizer
(13) Crossmember support plate
(Large type)
(14) Crossmember support plate
(Small type)
C: CAUTION
• Wear appropriate work clothing, including a cap,
protective goggles and protective shoes when per-
forming any work.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Use SUBARU genuine grease etc. or equivalent.
Do not mix grease etc. of different grades or man-
ufacturers.
• Before securing a part on a vise, place cushion-
ing material such as wood blocks, aluminum plate,
or cloth between the part and the vise.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
General Description
(15) Jack-up plate
(16) Dust seal
(17) Strut mount
(18) Spacer
(19) Upper spring seat
(20) Dust cover
(21) Helper
(22) Coil spring
(23) Strut
(24) Adjusting bolt
(25) Castle nut
(26) Self-locking nut
(27) Cotter pin
(28) Stopper
FS-4
(29) Flange nut
Tightening torque:N·m (kgf-m, ft-lb)
T1: 20 (2.0, 14.8)
T2: 25 (2.5, 18.4)
T3: 39 (4.0, 28.8)
T4: 45 (4.6, 33.2)
T5: 50 (5.1, 36.9)
T6: 55 (5.6, 40.6)
T7: 60 (6.1, 44.3)
T8: 95 (9.7, 70.1)
T9: 110 (11.2, 81.1)
T10: 150 (15.3, 110.6)
T11: 155 (15.8, 114.3)