Subaru 2009 IMPREZA Service Manual page 2097

B: INSTALLATION
1) Replace the differential side retainer oil seal.
<Ref. to 5MT-32, REPLACEMENT, Differential
Side Retainer Oil Seal.>
ST 18675AA000 DIFFERENTIAL SIDE OIL
SEAL INSTALLER
NOTE:
Be sure to replace the differential side retainer oil
seal after the removing the front drive shaft.
ST
2) Install the transmission cushion rubber to the
transmission, and tighten the bolt (A).
3) Install the transmission cushion rubber to the
center crossmember, and tighten the nut (B).
Tightening torque:
Bolt (A)
35 N·m (3.6 kgf-m, 25.8 ft-lb)
Nut (B)
35 N·m (3.6 kgf-m, 25.8 ft-lb)
(A)
(B)
4) Install the transmission onto the engine.
(1) Lift up the transmission gradually using a
transmission jack.
(2) Engage at the spline section.
NOTE:
Be careful not to hit the main shaft against the
clutch cover.
5) While raising the transmission jack, loosen the
turnbuckle of the ST, and set the engine unit to the
original position.
Manual Transmission Assembly
MT-00103
(A)
MT-01676
5MT-25
MANUAL TRANSMISSION AND DIFFERENTIAL
6) Install the front crossmember and rear cross-
member.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51.6 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103.3 ft-lb)
T 1
T 2
7) Take out the transmission jack.
8) Tighten the bolts and nuts which hold the lower
side of transmission to the engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
9) Connect the transmission to the engine.
(1) Install the starter. <Ref. to SC(H4SO)-7, IN-
STALLATION, Starter.>
(2) Tighten the bolts which hold the upper side
of the transmission to the engine.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
T 1
T 2
MT-01672
MT-00077
MT-01524