Subaru 2009 IMPREZA Service Manual page 2102

MANUAL TRANSMISSION AND DIFFERENTIAL
2. CROSSMEMBER AND CUSHION RUBBER
1) Install the transmission cushion rubber to the
transmission, and tighten the bolt (A).
2) Install the transmission cushion rubber to the
center crossmember, and tighten the nut (B).
Tightening torque:
Bolt (A)
35 N·m (3.6 kgf-m, 25.8 ft-lb)
Nut (B)
35 N·m (3.6 kgf-m, 25.8 ft-lb)
(A)
(B)
3) Install the front crossmember and rear cross-
member.
Tightening torque:
T1: 70 N·m (7.1 kgf-m, 51.6 ft-lb)
T2: 140 N·m (14.3 kgf-m, 103.3 ft-lb)
T 1
T 2
4) Remove the transmission jack.
5) Install the heat shield cover.
6) Install the front and center exhaust pipes. (Non-
turbo model) <Ref. to EX(H4SO)-7, INSTALLA-
TION, Front Exhaust Pipe.> <Ref. to EX(H4SO)-9,
INSTALLATION, Center Exhaust Pipe.>
Transmission Mounting System
(A)
MT-01676
T 1
T 2
MT-01672
MT-01660
5MT-30
7) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-10, INSTALLATION, Center
Exhaust Pipe.>
8) Install the rear exhaust pipe and muffler.
• Non-turbo model
<Ref. to EX(H4SO)-10, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H4SO)-12, INSTALLA-
TION, Muffler.>
• Turbo model
<Ref. to EX(H4DOTC)-13, INSTALLATION, Rear
Exhaust Pipe.> <Ref. to EX(H4DOTC)-15, IN-
STALLATION, Muffler.>
9) Lower the vehicle.
10) Connect the ground cable to battery.
C: INSPECTION
Perform the following inspection procedures and
repair or replace faulty parts.
1. PITCHING STOPPER
Check the pitching stopper for bends or damage.
Check that the rubber is not stiff, cracked or other-
wise damaged.
2. CROSSMEMBER AND CUSHION RUBBER
Check crossmember for bends or damage. Check
that the cushion rubber is not stiff, cracked, or oth-
erwise damaged.