Subaru 2009 IMPREZA Service Manual page 2173

Hide thumbs Also See for 2009 IMPREZA:

CLUTCH SYSTEM

7. Clutch Pipe and Hose

1) Remove the air intake chamber. (Non-turbo

model) <Ref. to IN(H4SO)-7, REMOVAL, Air Intake

2) Remove the intercooler. (Turbo model)

<Ref. to IN(H4DOTC)-13, REMOVAL, Intercool-

3) Drain the clutch fluid. <Ref. to CL-21, Clutch Flu-

4) Disconnect the clutch pipe from the clutch hose

and master cylinder.

5) Pull out the clamp, then disconnect the clutch

hose from the bracket.

(B) Clutch hose

6) Remove the hose from operating cylinder.

7) Remove the bracket.

Clutch Pipe and Hose

B: INSTALLATION

Install in the reverse order of removal.

• The illustration below is suitable for every model.

Perform the same procedures for the other models.

• Bleed air from the clutch fluid. <Ref. to CL-22,

Clutch Fluid Air Bleeding.>

Tightening torque:

T1: 15 N·m (1.5 kgf-m, 11.1 ft-lb)

T2: 18 N·m (1.8 kgf-m, 13.3 ft-lb)

T3: 25 N·m (2.5 kgf-m, 18.4 ft-lb)

(A) Clutch pipe

C: INSPECTION

Check pipes and hoses for cracks, breakage or

damage. Check joints for fluid leakage. If any

cracks, breakage, damage or leakage is found, re-

pair or replace the defective pipe or hose.