Subaru 2009 IMPREZA Service Manual page 2356

DRIVE SHAFT SYSTEM
7) Place alignment marks on the roller kit and trun-
nion.
8) Remove the roller kit from trunnion.
CAUTION:
Be careful with the roller kit position.
9) Place alignment marks on the trunnion and
shaft.
10) Remove the snap ring and trunnion.
CAUTION:
Be sure to wrap shaft splines with vinyl tape to
protect the boot from scratches.
Front Drive Shaft
11) Remove the AAR boot.
NOTE:
The AC is a non-disassembly part, so the drive
shaft disassembly stops here.
D: ASSEMBLY
NOTE:
Use specified grease.
AAR side:
ONE LUBER C
1) Pass the AAR boot through the shaft.
2) Align alignment marks and install the trunnion on
the shaft. Install the snap ring into the shaft groove
securely.
DS-00109
3) Fill 50 to 60 g (1.76 to 2.12 oz) of specified
grease into the interior of AAR outer race.
4) Apply a thin coat of specified grease to the roller
and trunnion.
5) Place the drive shaft between wooden blocks
and fix it on a vise.
CAUTION:
Do not fix the drive shaft on a vise directly.
6) Align the alignment marks on the shaft and outer
race.
7) Tap the insertion upper part of the outer race al-
ternately using a plastic or wood bar shown in the
figure, and then insert the roller one by one.
DS-00110
CAUTION:
• Do not use a metal bar as the outer race may
deform.
• Do not tap on the end of outer race (shaft
part).
• Be careful not to deform the baffle plate.
DS-00111
DS-28
DS-00110
DS-00420