Subaru 2009 IMPREZA Service Manual page 1967

Hide thumbs Also See for 2009 IMPREZA:

22) Install the planetary gear and low clutch as-

sembly to the transmission case.

Install carefully while rotating the low clutch and

planetary gear assembly slowly, being careful not

to damage the seal ring.

23) Measure the amount of drive plate compres-

sion and record that value. (Non-turbo model)

(1) Place the dish plate, driven plate, drive plate

and retaining plate neatly in this order on sur-

(2) Set the dial gauge to the clutch, and read its

The value, which is read in the gauge at this time, is

(3) Scale and record the weight "Z" of the flat

board that will be placed on the retaining plate.

• Use a stiff board which does not bend against

load as a flat board to be put on retaining plate.

• Use a flat board weighing less than 10.2 kg (22.5 lb).

(4) Put the flat board on retaining plate.

(5) Using the following formula, read the push/

pull gauge, and calculate "N".

N = 100 N (10.2 kgf, 22.5 lb) – Z

N: Value indicated on push/pull gauge

100 N (10.2 kgf, 22.5 lb) : Load applied to clutch

Z: Flat board weight

AT Main Case

(6) Press the center of retaining plate with a

force of N using a push/pull gauge, and mea-

sure and record height "A". Measure at three or

more locations spaced by equal distances and

take the average value.

If measuring in three locations, measure every

120°. If measuring in four locations, measure every

24) Install the pressure rear plate, 2-4 brake drive

plate, driven plate, retaining plate and snap ring.

AUTOMATIC TRANSMISSION

A Measured value

(A) Driven plate

(B) Drive plate