Subaru 2009 IMPREZA Service Manual page 1955

Hide thumbs Also See for 2009 IMPREZA:

6) Install new seal pipe to converter case.

(A) Seal pipe

7) Install the converter case to the transmission

case. <Ref. to 4AT-84, INSTALLATION, Converter

8) Insert the inhibitor switch connector and trans-

mission harness connector onto the stay.

(A) Transmission harness connectors

(B) Inhibitor switch connector

9) Install the ATF cooler pipe. <Ref. to 4AT-65, IN-

STALLATION, ATF Cooler Pipe and Hose.>

10) Install the oil charge pipe together with an O-

ring. <Ref. to 4AT-68, INSTALLATION, Oil Charge

11) Insert the input shaft while rotating it lightly by

hand, and then check the amount of protrusion.

Normal protrusion A:

50 — 55 mm (1.97 — 2.17 in)

A Measured value

Front Differential Assembly

12) Install the torque converter clutch assembly.

<Ref. to 4AT-69, INSTALLATION, Torque Convert-

er Clutch Assembly.>

13) Install the transmission assembly to the vehi-

cle. <Ref. to 4AT-40, INSTALLATION, Automatic

Transmission Assembly.>

C: DISASSEMBLY

1. DIFFERENTIAL CASE ASSEMBLY

1) Remove the taper roller bearing using the ST

and the press.

ST 498077000

2) Secure the case in a vise, remove the hypoid

driven gear tightening bolts, and then separate the

hypoid driven gear into differential case (RH) and

differential case (LH).

AUTOMATIC TRANSMISSION

(A) Hypoid driven gear

(B) Differential case (RH)