Subaru 2009 IMPREZA Service Manual page 2378

5. Rear ABS Wheel Speed
Sensor
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Disconnect the connector from the rear ABS
wheel speed sensor.
3) Remove the sensor harness clamp of the rear
sub frame.
4) Remove the sensor harness bracket from the
upper arm.
Rear ABS Wheel Speed Sensor
RS-00266
ABS-01015
RS-00257
ABS-15
5) Remove the rear ABS wheel speed sensor from
the rear axle.
CAUTION:
• Be careful not to damage the sensor.
• Do not apply excessive force to the sensor
harness.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
Be careful not to damage the sensor.
Tightening torque:
Sensor:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Bracket:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
NOTE:
Check the identification (mark) on the harness to
make sure there is no warpage. (RH: P5 (White),
LH: P6 (Yellow))
C: INSPECTION
1. ABS WHEEL SPEED SENSOR
<Ref. to ABS-14, ABS WHEEL SPEED SENSOR,
INSPECTION, Front ABS Wheel Speed Sensor.>
ABS
FU-03357