Subaru 2009 IMPREZA Service Manual page 2163

CLUTCH SYSTEM
2. Clutch Disc and Cover
A: REMOVAL
1) Remove the transmission assembly from vehicle
body.
<Ref. to 5MT-21, REMOVAL, Manual Transmis-
sion Assembly.>
2) Attach the ST on the flywheel.
ST 499747100 CLUTCH DISC GUIDE
( A )
(A) Clutch cover
3) Remove the clutch cover and clutch disc.
NOTE:
• Take care not to allow oil to touch the clutch disc
face.
• Do not disassemble the clutch cover or clutch
disc.
B: INSTALLATION
1) Insert the ST into the clutch disc and attach to
the flywheel by inserting the ST end into pilot bear-
ing.
NOTE:
When installing the clutch disc, be careful to attach
in the correct direction.
ST 499747100 CLUTCH DISC GUIDE
(A) Flywheel side
Clutch Disc and Cover
S T
CL-00011
(A)
ST
CL-00208
CL-10
2) Install the clutch cover to the flywheel and tight-
en the bolts to the specified torque.
NOTE:
• When installing the clutch cover to the flywheel,
position the clutch cover so that the distance be-
tween unbalance marks (
120°. (The unbalance mark
tion of residual unbalance.)
• Note the front and rear of the clutch disc when in-
stalling.
• Temporarily tighten the bolts by hand. Each bolt
should be tightened to the specified torque in a
crisscross order.
Tightening torque:
16 N·m (1.6 kgf-m, 11.8 ft-lb)
( 3 )
( 5 )
( 2 )
(A) Unbalance mark (paint)
3) Remove the ST.
ST 499747100 CLUTCH DISC GUIDE
4) Install the transmission assembly. <Ref. to 5MT-
25, INSTALLATION, Manual Transmission Assem-
bly.>
paint marks) is at least
indicates the direc-
( A )
( 1 )
( 6 )
S T
( 4 )
CL-00013