Subaru 2009 IMPREZA Service Manual page 1943

Hide thumbs Also See for 2009 IMPREZA:

B: INSTALLATION

1) Secure the oil pump housing with two nuts and a

Tightening torque:

42 N·m (4.3 kgf-m, 31.0 ft-lb)

(A) Oil pump housing

2) Install the converter case to the transmission

case assembly. <Ref. to 4AT-84, INSTALLATION,

Converter Case.>

3) Install the reduction driven gear. <Ref. to 4AT-

78, INSTALLATION, Reduction Driven Gear.>

4) Install the reduction drive gear. <Ref. to 4AT-80,

INSTALLATION, Reduction Drive Gear.>

5) Join the transmission case and the extension

case, and then install the rear vehicle speed sen-

sor. <Ref. to 4AT-71, INSTALLATION, Extension

6) Insert the inhibitor switch connector and trans-

mission harness connector onto the stay.

(A) Transmission harness connectors

(B) Inhibitor switch connector

7) Install the ATF cooler pipe. <Ref. to 4AT-65, IN-

STALLATION, ATF Cooler Pipe and Hose.>

8) Install the oil charge pipe together with an O-

ring. <Ref. to 4AT-68, INSTALLATION, Oil Charge

Oil Pump Housing

AUTOMATIC TRANSMISSION

9) Insert the input shaft while rotating it lightly by

hand, and then check the amount of protrusion.

Normal protrusion A:

50 — 55 mm (1.97 — 2.17 in)

A Measured value

10) Install the torque converter clutch assembly.

<Ref. to 4AT-69, INSTALLATION, Torque Convert-

er Clutch Assembly.>

11) Install the transmission assembly to the vehi-

cle. <Ref. to 4AT-40, INSTALLATION, Automatic

Transmission Assembly.>