Subaru 2009 IMPREZA Service Manual page 2133

3) Install the 1st driven gear, inner baulk ring, syn-
chro cone, outer baulk ring, and gear & hub assem-
bly onto driven shaft.
(A)
(D)
(C) (B)
(A) 1st driven gear
(B) Synchro cone
(C) Inner baulk ring
(D) Outer baulk ring
NOTE:
• Take care to install the gear and hub assembly in
proper direction.
• Align the baulk ring and gear & hub assembly
with the key groove.
4) Install the 2nd driven gear bushing onto driven
shaft using ST1, ST2 and a press.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
NOTE:
• Attach a cloth to the end of the driven shaft to
prevent damage.
• When press fitting, align the oil holes of the shaft
and bushing
ST1 499277200 INSTALLER
ST2 499587000 INSTALLER
Drive Pinion Shaft Assembly
5) Install the 2nd driven gear, inner baulk ring, syn-
chro cone and outer baulk ring, and insert them
onto driven shaft.
MT-01634
6) After installing key on driven shaft, install the
3rd-4th driven gear using an ST and a press.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
NOTE:
Align the groove in baulk ring with the insert.
ST 499277200
7) Install a set of roller bearings onto the driven
shaft using ST and a press.
ST1
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST2
ST 499277200
MT-00253
5MT-61
MANUAL TRANSMISSION AND DIFFERENTIAL
(D)
(B)
(A) 2nd driven gear
(B) Synchro cone
(C) Inner baulk ring
(D) Outer baulk ring
INSTALLER
INSTALLER
(A)
(C)
MT-01633
ST
MT-00255
ST
MT-00256