Subaru 2009 IMPREZA Service Manual page 2373

ABS
3. ABS Sequence Control
A: OPERATION
1) While the ABS sequence control is being per-
formed, the operation of the hydraulic unit can be
checked using the brake tester or pressure gauge
after the hydraulic unit solenoid valve operation.
2) ABS sequence control can be started by the
Subaru Select Monitor.
1. ABS SEQUENCE CONTROL WITH
SUBARU SELECT MONITOR
NOTE:
In the event of any trouble, the ABS sequence con-
trol will not operate.
1) Connect the Subaru Select Monitor to data link
connector under the driver's side instrument panel
lower cover.
2) Turn the ignition switch to ON.
3) Run the "PC application for Subaru Select Mon-
itor".
4) Set the Subaru Select Monitor to "Brake Control"
mode.
5) When the "Function check sequence" is select-
ed, the "ABS sequence control" will start.
6) Execute the following operations when the mes-
sage "Press the brake pedal so that the brake ped-
al force is between 100 and 150 kgf" is displayed.
(1) When using a brake tester, press the brake
pedal pad with a force of 1,000 N (102 kgf, 225
lbf).
(2) When using a pressure gauge, press the
brake pedal so that the pressure gauge indi-
cates 3,500 kPa (36 kgf/cm
7) The brake system being operated is displayed
on the Subaru Select Monitor.
ABS Sequence Control
2
, 511 psi).
ABS-10