Subaru 2009 IMPREZA Service Manual page 2118

MANUAL TRANSMISSION AND DIFFERENTIAL
C: DISASSEMBLY
1) Cover the reverse check sleeve with a rag, and
remove the snap ring using a screwdriver.
NOTE:
Replace the snap ring with a new part if it is de-
formed or spring force is weakened.
(A) Snap ring
2) Remove the reverse check plate, reverse check
spring, reverse check cam, return spring (5th-Rev),
reverse accent shaft, return spring cap and return
spring (1st-2nd).
(A)
(C)
(B)
(D)
(F)
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
3) Remove the O-ring.
NOTE:
• Visually check the O-ring. Replace if faulty.
• Be careful not to damage the adjusting shim be-
tween reverse check sleeve assembly and the
case.
Reverse Check Sleeve
(A)
MT-00153
(E)
(G)
MT-00154
D: ASSEMBLY
1) Install the return spring (1st-2nd), return spring
cap, reverse accent shaft, reverse check cam, re-
turn spring (5th-Rev) and reverse check spring to
the reverse check sleeve.
NOTE:
Be sure to position the bent section of reverse
check spring to fit in the groove of the check cam.
(B)
(D)
(A) Reverse check plate
(B) Reverse check spring
(C) Return spring (5th-Rev)
(D) Reverse check cam
(E) Reverse accent shaft
(F) Return spring cap
(G) Return spring (1st-2nd)
2) Hook the curved section of the reverse check
spring over the reverse check plate.
3) Rotate the cam so that the protrusion of the re-
verse check cam comes to the opening of the plate.
4) With cam held in that position, install the reverse
check plate onto the reverse check sleeve and hold
in place with the snap ring.
5) Position the new O-ring in the groove of sleeve.
5MT-46
(A)
(C)
(E)
(G)
(F)
MT-00154