Subaru 2009 IMPREZA Service Manual page 2181

CLUTCH SYSTEM
2) Check the clutch switch for continuity. If the re-
sistance is not at the standard value, replace the
switch.
(1) Disconnect the clutch switch connector.
(2) Measure the resistance between terminal 1
and 2 of the switch.
• Clutch switch (cruise control)
Condition
When clutch pedal is
No. 1 — No. 2
depressed
When the clutch pedal
No. 1 — No. 2
is not depressed
• Clutch switch (clutch start)
Condition
When clutch pedal is
No. 1 — No. 2
depressed
When the clutch pedal
No. 1 — No. 2
is not depressed
3) Make sure that engine does not start with clutch
pedal not depressed. If the engine starts, adjust the
clutch switch and check the clutch start circuit.
4) Make sure that engine starts with clutch pedal
fully depressed. If the engine does not start, adjust
the clutch switch and check the clutch start circuit.
Clutch Switch
Specified
Terminal No.
resistance
1 M or more
Less than 1
2 1
CL-00084
Specified
Terminal No.
resistance
Less than 1
1 M or more
1
2
CL-00102
D: ADJUSTMENT
1) Loosen the lock nut of clutch switch (clutch
start).
(A) Lock nut
(B) Clutch switch (clutch start)
2) Fully depress the clutch pedal and hold it.
3) Adjust the gap of the clutch pedal plate and the
clutch switch to be 3 — 3.5 mm (0.12 — 0.14 in).
(A) Plate
(B) Clutch switch (clutch start)
(C) 3 — 3.5 mm (0.12 — 0.14 in)
4) Tighten the lock nut.
Tightening torque:
8 N·m (0.8 kgf-m, 5.9 ft-lb)
CL-28
(A)
(B)
CL-00105
(A)
(C)
(B)
CL-00104