Subaru 2009 IMPREZA Service Manual page 2000

Hide thumbs Also See for 2009 IMPREZA:

6. Subaru Select Monitor

A: OPERATION

1. READ DIAGNOSTIC TROUBLE CODE

1) Prepare the Subaru Select Monitor kit.

2) Prepare PC with Subaru Select Monitor in-

3) Connect the USB cable to SDI (Subaru Diagno-

sis Interface) and USB port on the personal com-

puter (dedicated port for the Subaru Select

The dedicated port for the Subaru Select Monitor

means the USB port which was used to install the

Subaru Select Monitor.

4) Connect the diagnosis cable to SDI.

5) Connect SDI to data link connector located in the

lower portion of the instrument panel (on the driv-

Do not connect the scan tools other than the

Subaru Select Monitor.

6) Start the PC.

7) Turn the ignition switch to ON.

8) Run the "PC application for Subaru Select Mon-

9) On «Main Menu» display, select {Each System

10) On «System Selection Menu» display, select

{Transmission Control System}.

11) After transmission type information pops up,

select [OK].

12) On «Transmission Diagnosis» display, select

{Diagnostic Code(s) Display}.

Subaru Select Monitor

13) On «Diagnostic Code(s) Display» display, se-

lect {Temporary Diagnostic Code(s)} or {Memo-

rized Diagnostic Code(s)}.

• For details concerning the operation procedure,

refer to "PC application help for Subaru Select

• For details concerning DTC, refer to "List of Diag-

nostic Trouble Code (DTC)". <Ref. to 4AT(diag)-

29, List of Diagnostic Trouble Code (DTC).>

4AT(diag)-15

AUTOMATIC TRANSMISSION (DIAGNOSTICS)