Subaru 2009 IMPREZA Service Manual page 1851

CONTROL SYSTEMS
B: INSTALLATION
1) Install the joint to the transmission and secure
with a spring pin.
(B)
(A) Joint
(B) Spring pin
2) Insert the gear shift lever from the room side.
NOTE:
Insert the rod and the stay, and then temporarily set
them onto the transmission mount.
3) Lift up the vehicle.
4) Mount the cushion rubber on the vehicle body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
(A)
(A) Stay
(B) Cushion rubber
MT Gear Shift Lever
(A)
CS-00053
CS-00884
(B)
CS-00052
5) Using new self-locking nuts, connect the rod to
the joint.
Tightening torque:
12 N·m (1.2 kgf-m, 8.9 ft-lb)
(A) Stay
(B) Rod
6) Using new self-locking nuts, connect the stay to
the transmission bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
(A)
(A) Stay
(B) Transmission bracket
7) Install the heat shield cover.
CS-34
(A)
(B)
CS-00051
(B)
CS-00050
MT-01660