Subaru 2009 IMPREZA Service Manual page 2178

2) If the full stroke is not within the specified value,
loosen the clutch switch lock nut to adjust.
Tightening torque:
8 N·m (0.8 kgf-m, 5.9 ft-lb)
3) Loosen the push rod lock nuts.
(D)
(C)
(A) Clevis pin
(B) Snap pin
(C) Push rod
(D) Push rod lock nut
4) Rotate the push rod to adjust.
(1) Make sure that the clutch pedal contacts the
clutch switch side when the pedal is released.
(2) Make sure that the clutch pedal contacts the
clutch pedal bracket stopper when the clutch
pedal is at the maximum stroke position.
(A)
(B)
(C)
(D)
(A) Clevis hole
(B) Push rod lock nut
(C) In the shorter direction
(D) In the longer direction
(E) Push rod
(F) Clevis
Clutch Pedal
(A)
(B)
CL-00042
(F)
(E)
CL-00080
5) Turn the push rod to shorten until a clearance is
gained on the clutch switch side.
(A) Clutch switch
(B) Stopper
6) Turn the push rod to lengthen until clutch pedal
contacts the clutch switch.
7) Turn further in the direction that will shorten the
push rod (arrow direction shown in figure) by 270°.
(A) Accelerator pedal
(B) Clevis
8) Check that the clevis pin moves smoothly by
moving it in the left and right directions.
9) Tighten the push rod lock nut.
Tightening torque (Push rod lock nut):
T: 10 N·m (1.0 kgf-m, 7.4 ft-lb)
(C)
(A) Clevis pin
(B) Snap pin
(C) Push rod
CL-25
CLUTCH SYSTEM
(A)
(B)
CL-00100
(B)
(A)
CL-00600
(A)
(B)
T
CL-00226