Subaru 2009 IMPREZA Service Manual page 1842

4. Select Cable
A: REMOVAL
1) Set the vehicle on a lift.
2) Shift the select lever to "N" range.
3) Disconnect the ground cable from battery.
4) Lift up the vehicle.
5) Remove the front, center and rear exhaust pipes
and the muffler. (Non-turbo model) <Ref. to
EX(H4SO)-6, REMOVAL, Front Exhaust Pipe.>
<Ref. to EX(H4SO)-9, REMOVAL, Center Exhaust
Pipe.> <Ref. to EX(H4SO)-10, REMOVAL, Rear
Exhaust Pipe.> <Ref. to EX(H4SO)-12, REMOV-
AL, Muffler.>
6) Remove the center and rear exhaust pipes and
the muffler. (Turbo model) <Ref. to EX(H4DOTC)-
8, REMOVAL, Center Exhaust Pipe.> <Ref. to
EX(H4DOTC)-13, REMOVAL,
Pipe.> <Ref. to EX(H4DOTC)-15, REMOVAL, Muf-
fler.>
7) Remove the heat shield cover.
8) Remove the snap pin and washer from shifter
arm.
(C)
(D)
(A) Shifter arm
(B) Snap pin
(C) Select cable
(D) Bracket
(E) Washer
Select Cable
Rear Exhaust
AT-04522
(E)
(B)
(A)
CS-00954
CS-25
9) Remove the plate assembly from the transmis-
sion case.
(A)
(B)
(A) Select cable
(B) Plate ASSY
10) Disconnect the cable from arm assembly.
(A) Adjusting nut
(B) Arm ASSY
11) Raise the claw of clamp to remove the cable
from bracket.
(A) Claw
12) Remove the select cable from plate assembly.
CONTROL SYSTEMS
CS-00955
(B)
(A)
CS-00278
(A)
CS-00279