Subaru 2009 IMPREZA Service Manual page 1906

AUTOMATIC TRANSMISSION
D: INSTALLATION
1) Connect the inhibitor switch harness connector
to the inhibitor switch.
2) Install the inhibitor switch to the transmission
case.
(A) Inhibitor switch
3) Install the shifter arm and fix with a new spring
pin.
(A) Spring pin
(B) Shifter arm
4) Move the shifter arm to the neutral position.
5) Using the ST, tighten the two bolts holding the
inhibitor switch.
ST 499267300 STOPPER PIN
Tightening torque:
5 N·m (0.5 kgf-m, 3.7 ft-lb)
S T
(A) Inhibitor switch
(B) Shifter arm
6) Install the select cable to the shifter arm.
Inhibitor Switch
(A)
AT-04786
(B)
(A)
AT-04868
(B)
(A)
AT-04869
7) Install the plate assembly to the transmission.
Tightening torque:
T: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
T
(B)
(A) Select cable
(B) Plate ASSY
8) Install the washer and snap pin to the shifter
arm.
(A) Shifter arm
(B) Snap pin
(C) Select cable
(D) Washer
9) Install the front and center exhaust pipes. (Non-
turbo model) <Ref. to EX(H4SO)-7, INSTALLA-
TION, Front Exhaust Pipe.> <Ref. to EX(H4SO)-9,
INSTALLATION, Center Exhaust Pipe.>
10) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-10, INSTALLATION, Center
Exhaust Pipe.>
11) Lower the vehicle.
12) Inspect the inhibitor switch. <Ref. to 4AT-48,
INSPECTION, Inhibitor Switch.>
4AT-50
(A)
CS-00956
(D)
(B)
(C)
(A)
AT-04867