Pipe Assembly - Subaru 2009 IMPREZA Service Manual

6. Pipe Assembly

A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift up the vehicle, and then remove the front
crossmember support plate and jack-up plate.
• Large type
(1) Front crossmember support plate
• Small type
(1)
(1) Front crossmember support plate
(2) Jack-up plate
3) Remove the one pipe joint at the center of the
gearbox, and connect the vinyl hose to the pipe and
the joint. Discharge the fluid by turning the steering
wheel fully clockwise and counterclockwise. Dis-
charge the fluid similarly from other pipes.
(1) Pipe A
(2) Pipe B
Pipe Assembly
(1)
PS-00445
(1)
(2)
FS-00105
(1)
(2)
PS-00553
POWER ASSISTED SYSTEM (POWER STEERING)
4) Remove the clamp E from return hose and pres-
sure hose.
(1) Return hose
(2) Pressure hose
(3) Clamp E
5) Disconnect the pipe D from return hose and pipe
C from pressure hose.
(1) Pipe C
(2) Pipe D
(3) Pressure hose
(4) Return hose
6) Remove the air intake duct.
PS-37
(3)
(2)
(1)
PS-00537
(4)
(3)
(2)
(1)
PS-00538