Subaru 2009 IMPREZA Service Manual page 1940

AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Check the appearance of each component and
clean them.
2) Press-fit the new oil seal to converter case using
ST.
ST 398437700 DRIFT
3) Install the front differential assembly to the case.
<Ref. to 4AT-98, INSTALLATION, Front Differen-
tial Assembly.>
4) Install the right and left side retainers. <Ref. to
4AT-102, ADJUSTMENT, Front Differential As-
sembly.>
5) Install new seal pipe to converter case.
(A) Seal pipe
6) Install new rubber seal to converter case.
(A) Rubber seal
Converter Case
7) Apply proper amount of liquid gasket to the en-
tire matching surface of converter case.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
AT-00177
8) Install the converter case, being careful not to
damage the bushing and oil seal.
NOTE:
Use new bolts for the oil charge pipe.
Tightening torque:
Oil charge pipe section
Excluding the oil charge pipe section
AT-00176
(A)
9) Insert the inhibitor switch connector and trans-
mission harness connector onto the stay.
10) Install the air breather hose. <Ref. to 4AT-67,
INSTALLATION, Air Breather Hose.>
11) Install the ATF cooler pipe. <Ref. to 4AT-65, IN-
STALLATION, ATF Cooler Pipe and Hose.>
12) Install the oil charge pipe with O-ring. <Ref. to
4AT-68, INSTALLATION, Oil Charge Pipe.>
AT-00178
4AT-84
(A)
(A) THREE BOND 1215
(B) Rubber seal
38 N·m (3.9 kgf-m, 28.0 ft-lb)
41 N·m (4.2 kgf-m, 30.2 ft-lb)
(B)
AT-00179
AT-04678