Subaru 2009 IMPREZA Service Manual page 1822

Hide thumbs Also See for 2009 IMPREZA:

C: PREPARATION TOOL

1. SPECIAL TOOL

ILLUSTRATION

2. GENERAL TOOL

Circuit tester

• Wear appropriate work clothing, including a cap,

protective goggles and protective shoes when per-

forming any work.

• Remove contamination including dirt and corro-

sion before removal, installation or disassembly.

• Keep the disassembled parts in order and pro-

tect them from dust and dirt.

• Before removal, installation or disassembly, be

sure to clarify the failure. Avoid unnecessary re-

moval, installation, disassembly and replacement.

• Use SUBARU genuine fluid, grease etc. or

equivalent. Do not mix fluid, grease, etc. of different

grades or manufacturers.

• Be sure to tighten fasteners including bolts and

nuts to the specified torque.

• Place shop jacks or rigid racks at the specified

• Apply grease onto sliding or revolving surfaces

before installation.

• Before installing O-rings or snap rings, apply suf-

ficient amount of fluid to avoid damage and defor-

• Before securing a part in a vise, place cushioning

material such as wood blocks, aluminum plate or

cloth between the part and the vise.

• Before disconnecting electrical connectors, be

sure to disconnect the negative terminal from bat-

General Description

SUBARU SELECT

MONITOR III KIT

Used for measuring resistance and voltage.

CONTROL SYSTEMS

Used for troubleshooting the electrical system.