Subaru 2009 IMPREZA Service Manual page 2100

MANUAL TRANSMISSION AND DIFFERENTIAL
26) Install the ground cable.
Tightening torque:
13 N·m (1.3 kgf-m, 9.6 ft-lb)
27) Install the engine hanger rear, and then con-
nect the engine harness connector. (Non-turbo
model)
Tightening torque:
16 N·m (1.6 kgf-m, 11.8 ft-lb)
(A)
(A) Engine harness connectors
(B) Engine connector
28) Install the engine hanger. (Turbo model)
Tightening torque:
16 N·m (1.6 kgf-m, 11.8 ft-lb)
Manual Transmission Assembly
MT-01650
(B)
MT-01651
AT-04582
5MT-28
29) Connect the following connectors.
• Non-turbo model
(A) Neutral position switch connector (Brown)
(B) Back-up light switch connector (Gray)
• Turbo model
(B)
(A) Neutral position switch and back-up light switch
connector
(B) Rear oxygen sensor connector
30) Install the air intake chamber stay. (Non-turbo
model)
Tightening torque:
16 N·m (1.6 kgf-m, 11.8 ft-lb)
31) Install the air intake chamber and intake boot.
(Non-turbo model)
<Ref. to IN(H4SO)-7, INSTALLATION, Air Intake
Chamber.>
32) Install the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-13, INSTALLATION, Intercooler.>
33) Connect the ground cable to battery.
34) Remove the lift arm from vehicle.
(A)
(B)
MT-01648
(A)
MT-01649