Subaru 2009 IMPREZA Service Manual page 1985

Hide thumbs Also See for 2009 IMPREZA:

35.Transmission Control Device

1) Remove the transmission assembly from the ve-

hicle. <Ref. to 4AT-36, REMOVAL, Automatic

Transmission Assembly.>

2) Pull out the torque converter clutch assembly.

<Ref. to 4AT-69, REMOVAL, Torque Converter

Clutch Assembly.>

3) Remove the input shaft.

4) Lift up the lever on the rear side of transmission

harness connector, and then remove it from the

5) Remove the inhibitor switch connector from the

6) Disconnect the air breather hose. <Ref. to 4AT-

67, REMOVAL, Air Breather Hose.>

7) Wrap vinyl tape around the nipple attached to

the air breather hose.

8) Remove the pitching stopper bracket.

9) Remove the inhibitor switch. <Ref. to 4AT-49,

REMOVAL, Inhibitor Switch.>

10) Remove the control valve body assembly.

<Ref. to 4AT-58, REMOVAL, Control Valve Body.>

11) Pull out the manual plate spring pin.

Transmission Control Device

12) Remove the bolts securing select lever, and

then remove the select lever, manual plate and

parking rod.

Be careful not to damage the lips of press-fitted oil

seal in the case.

13) Remove the detent spring.

B: INSTALLATION

1) Install the detent spring to the transmission

Tightening torque:

AUTOMATIC TRANSMISSION

(B) Range select lever

(D) Parking rod

6 N·m (0.6 kgf-m, 4.4 ft-lb)