Subaru 2009 IMPREZA Service Manual page 1901

2. TRANSMISSION REAR CROSSMEMBER
AND REAR CUSHION RUBBER
1) Install the rear cushion rubber.
Tightening torque:
40 N·m (4.1 kgf-m, 29.5 ft-lb)
2) Install the transmission rear crossmember.
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 25.8 ft-lb)
T2: 70 N·m (7.1 kgf-m, 51.6 ft-lb)
T 2
3) Remove the transmission jack.
4) Install the heat shield cover.
5) Install the front, center and rear exhaust pipes,
and the muffler. (Non-turbo model)
<Ref. to EX(H4SO)-7, INSTALLATION, Front Ex-
haust Pipe.> <Ref. to EX(H4SO)-9, INSTALLA-
TION, Center Exhaust Pipe.> <Ref. to EX(H4SO)-
10, INSTALLATION, Rear Exhaust Pipe.> <Ref. to
EX(H4SO)-12, INSTALLATION, Muffler.>
6) Install the center, rear exhaust pipes and the
muffler. (Turbo model) <Ref. to EX(H4DOTC)-10,
INSTALLATION, Center Exhaust Pipe.> <Ref. to
EX(H4DOTC)-13, INSTALLATION, Rear Exhaust
Pipe.> <Ref. to EX(H4DOTC)-15, INSTALLATION,
Muffler.>
7) Lower the vehicle.
8) Connect the ground cable to battery.
Transmission Mounting System
T 1
T 2
AT-03698
AT-04522
C: INSPECTION
If problems are found in the following inspection,
repair or replace the part.
1. PITCHING STOPPER
Make sure that the pitching stopper is not bent or
damaged. Check that there are no cracks, harden-
ing or damage on rubber parts.
2. TRANSMISSION REAR CROSSMEMBER
AND REAR CUSHION RUBBER
Make sure that the crossmember is not bent or
damaged. Check that there are no cracks, harden-
ing, or damage on cushion rubbers.
4AT-45
AUTOMATIC TRANSMISSION