Subaru 2009 IMPREZA Service Manual page 1827

CONTROL SYSTEMS
D: INSPECTION
1. SHIFT LOCK OPERATION
Step
1 CHECK COMMUNICATION OF SUBARU SE-
LECT MONITOR.
1) Turn the ignition switch to ON.
2) Using the Subaru Select Monitor, check
whether communication to all systems can be
executed normally.
2 CHECK SHIFT LOCK.
1) Turn the ignition switch to ON.
2) Shift the select lever to "P" range.
3 CHECK SHIFT LOCK.
4 CHECK SHIFT LOCK.
Shift the select lever to "N" range.
AT Shift Lock Control System
Is the system name displayed? Go to step 2.
While brake pedal is not
depressed, is it possible to
move the select lever from the
"P" range to other ranges?
While brake pedal is
depressed, is it possible to
move the select lever from the
"P" range to other ranges?
Is it possible to move the select
lever from the "N" range to the
"P" range?
CS-10
Check Yes
Perform the
inspection of
"SELECT LEVER
CANNOT BE
LOCKED OR
RELEASED".
<Ref. to CS-14,
SELECT LEVER
CANNOT BE
LOCKED OR
RELEASED,
INSPECTION, AT
Shift Lock Control
System.>
Go to step 4.
Go to step 5.
No
Perform the
inspection follow-
ing the diagnostic
procedure in the
LAN section. <Ref.
to LAN(diag)-2,
Basic Diagnostic
Procedure.>
Go to step 3.
Perform the
inspection of
"SELECT LEVER
CANNOT BE
LOCKED OR
RELEASED".
<Ref. to CS-14,
SELECT LEVER
CANNOT BE
LOCKED OR
RELEASED,
INSPECTION, AT
Shift Lock Control
System.>
Perform the
inspection of
"SELECT LEVER
CANNOT BE
LOCKED OR
RELEASED".
<Ref. to CS-14,
SELECT LEVER
CANNOT BE
LOCKED OR
RELEASED,
INSPECTION, AT
Shift Lock Control
System.>