Subaru 2009 IMPREZA Service Manual page 2444

4. VDC CONTROL MODULE & HYDRAULIC CONTROL UNIT (VDCCM&H/U)
T2
(1) VDC control module & hydraulic
control unit (VDCCM&H/U)
(2) Front RH outlet
(3) Rear LH outlet
(4) Rear RH outlet
(5) Front LH outlet
C: CAUTION
• Wear appropriate work clothing, including a cap,
protective goggles and protective shoes when per-
forming any work.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before disconnecting connectors of sensors or
units, be sure to disconnect the ground cable from
the battery.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly and replacement.
• Vehicle components are extremely hot after driv-
ing. Be wary of receiving burns from heated parts.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
General Description
(2)
(6)
T2
(11)
(6) Primary inlet
(7) Secondary inlet
(8) Damper
(9) Spacer
(10) Damper
VDC-5
VEHICLE DYNAMICS CONTROL (VDC)
(5)
(4)
(3)
(7)
(1)
(9)
(8)
T2
(10)
T1
(11) Bracket
Tightening torque:N·m (kgf-m, ft-lb)
T1: 7.5 (0.76, 5.5)
T2: 33 (3.4, 24.3)
VDC00480