Subaru 2009 IMPREZA Service Manual page 2101

4. Transmission Mounting
System
A: REMOVAL
1. PITCHING STOPPER
1) Disconnect the ground cable from battery.
2) Remove the air intake chamber and intake boot.
(Non-turbo model) <Ref. to IN(H4SO)-7, REMOV-
AL, Air Intake Chamber.>
3) Remove the intercooler. (Turbo model) <Ref. to
IN(H4DOTC)-13, REMOVAL, Intercooler.>
4) Remove the pitching stopper.
2. CROSSMEMBER AND CUSHION RUBBER
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the front and center exhaust pipes.
(Non-turbo model) <Ref. to EX(H4SO)-6, REMOV-
AL, Front Exhaust Pipe.> <Ref. to EX(H4SO)-9,
REMOVAL, Center Exhaust Pipe.>
4) Remove the center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-8, REMOVAL, Center Ex-
haust Pipe.>
5) Remove the rear exhaust pipe and muffler.
• Non-turbo model
<Ref. to EX(H4SO)-10, REMOVAL, Rear Exhaust
Pipe.> <Ref. to EX(H4SO)-12, REMOVAL, Muf-
fler.>
• Turbo model
<Ref. to EX(H4DOTC)-13, REMOVAL, Rear Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-15, REMOV-
AL, Muffler.>
6) Remove the heat shield cover.
Transmission Mounting System
MT-00069
MT-01660
5MT-29
MANUAL TRANSMISSION AND DIFFERENTIAL
7) Set the transmission jack under the transmission
body.
CAUTION:
Always support the transmission case with a
transmission jack.
8) Remove the front crossmember and the rear
crossmember.
9) Remove the transmission cushion rubber.
B: INSTALLATION
1. PITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
T2
2) Install the air intake chamber and intake boot.
(Non-turbo model) <Ref. to IN(H4SO)-7, INSTAL-
LATION, Air Intake Chamber.>
3) Install the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-13, INSTALLATION, Inter-
cooler.>
4) Connect the battery ground cable to the battery.
MT-01851
T1
MT-00085