Subaru 2009 IMPREZA Service Manual page 1852

8) Install the rear exhaust pipe and muffler.
• Non-turbo model
<Ref. to EX(H4SO)-10, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H4SO)-12, INSTALLA-
TION, Muffler.>
• Turbo model
<Ref. to EX(H4DOTC)-13, INSTALLATION, Rear
Exhaust Pipe.> <Ref. to EX(H4DOTC)-15, IN-
STALLATION, Muffler.>
9) Install the plate assembly to the body.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
(1) Set the plate assembly to the vehicle.
(2) Temporarily tighten the bolt (A).
(3) Tighten the bolt (B).
(4) Tighten the bolt (A).
(5) Tighten the bolts (C) and (D).
(C)
(D)
10) Install the harness clamp to the plate.
11) Install the boot and insulator assembly, and se-
cure with a clamp.
12) Install the console cover and console box.
<Ref. to EI-48, INSTALLATION, Console Box.>
13) Install the console front panel and console
boot.
14) Install the gear shift knob.
15) Make sure the gears can be shifted accurately
into each gear.
MT Gear Shift Lever
C: DISASSEMBLY
1) Remove the lock wires.
2) Remove the rod from lever.
(B)
(A)
CS-00737
3) Separate the rod and inner boot.
4) Remove the snap ring from the stay.
CS-00899
CS-35
(A) Lock wire
(A)
(C)
(A) Rod
(B) Lever
(C) Stay
(A)
(A) Snap ring
CONTROL SYSTEMS
(A)
CS-00316
(B)
CS-00317
CS-00318