Subaru 2009 IMPREZA Service Manual page 2607

Hide thumbs Also See for 2009 IMPREZA:

2. REAR BRAKE HOSE

1) Route the brake hose through the hole of brack-

et, and lightly tighten the flare nut to connect brake

2) Insert the clamp to secure brake hose.

(1) Brake pipe

(2) Brake hose clamp

(3) Brake hose

3) Install the brake hose bracket.

Tightening torque:

33 N·m (3.4 kgf-m, 24.3 ft-lb)

4) Install the brake hose to rear brake caliper using

a new gasket.

Tightening torque (union bolt):

18 N·m (1.8 kgf-m, 13.3 ft-lb)

• Disc brake

• Drum brake

5) Tighten the flare nut to the specified torque.

Tightening torque (brake pipe flare nut):

15 N·m (1.5 kgf-m, 11.1 ft-lb)

6) Bleed air from the brake system.

C: INSPECTION

Make sure there are no cracks, breakage or dam-

age on hoses. Check the joint for fluid leakage. If

any cracks, breakage, damage or fluid leakage is

found, repair or replace the hose.