Subaru 2009 IMPREZA Service Manual page 1970

Hide thumbs Also See for 2009 IMPREZA:

AUTOMATIC TRANSMISSION

33) Install the high clutch assembly and reverse

clutch assembly.

(A) High clutch ASSY and reverse clutch ASSY

34) Adjust the total end play. <Ref. to 4AT-91, AD-

JUSTMENT, Oil Pump Housing.>

35) Install the thrust needle bearing in the correct

(A) High clutch ASSY and reverse clutch ASSY

(B) Thrust needle bearing

(D) Downside

36) Install a new gasket along with the oil pump

housing assembly. <Ref. to 4AT-87, INSTALLA-

TION, Oil Pump Housing.>

37) Install the converter case to the transmission

case assembly. <Ref. to 4AT-84, INSTALLATION,

Converter Case.>

AT Main Case

38) Insert the inhibitor switch connector and trans-

mission harness connector onto the stay.

(A) Transmission harness connectors

(B) Inhibitor switch connector

39) Install the air breather hose. <Ref. to 4AT-67,

INSTALLATION, Air Breather Hose.>

40) Install the ATF cooler pipe. <Ref. to 4AT-65, IN-

STALLATION, ATF Cooler Pipe and Hose.>

41) Install the oil charge pipe together with an O-

ring. <Ref. to 4AT-68, INSTALLATION, Oil Charge

42) Insert the input shaft while rotating it lightly by

hand, and then check the amount of protrusion.

Normal protrusion A:

50 — 55 mm (1.97 — 2.17 in)

A Measured value

43) Install the torque converter clutch assembly.

<Ref. to 4AT-69, INSTALLATION, Torque Convert-

er Clutch Assembly.>

44) Install the transmission assembly to the vehi-

cle. <Ref. to 4AT-40, INSTALLATION, Automatic

Transmission Assembly.>