Subaru 2009 IMPREZA Service Manual page 2477

Hide thumbs Also See for 2009 IMPREZA:

6. Subaru Select Monitor

A: OPERATION

1. HOW TO USE SUBARU SELECT

1) Prepare the Subaru Select Monitor kit. <Ref. to

VDC(diag)-8, SPECIAL TOOL, PREPARATION

TOOL, General Description.>

2) Prepare PC with Subaru Select Monitor in-

3) Connect the USB cable to SDI (Subaru Diagno-

sis Interface) and USB port on the personal com-

puter (dedicated port for the Subaru Select

The dedicated port for the Subaru Select Monitor

means the USB port which was used to install the

Subaru Select Monitor.

4) Connect the diagnosis cable to SDI.

5) Connect SDI to data link connector located in the

lower portion of the instrument panel (on the driv-

Do not connect the scan tools other than the

Subaru Select Monitor.

6) Start the PC.

7) Turn the ignition switch to ON (engine OFF) and

run the "PC application for Subaru Select Monitor".

For detailed operation procedures, refer to "PC ap-

plication help for Subaru Select Monitor".

Subaru Select Monitor

VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS)

8) If VDC and Subaru Select Monitor cannot com-

municate, check the communication circuit. <Ref.

to VDC(diag)-19, COMMUNICATION FOR INI-

TIALIZING IMPOSSIBLE, INSPECTION, Subaru

Select Monitor.>

VDC(diag)-15