Subaru 2009 IMPREZA Service Manual page 2202

FRONT SUSPENSION
C: DISASSEMBLY
1. FRONT BUSHING
Using the ST and a press, remove the front bush-
ing.
ST 927680000 INSTALLER & REMOVER
SET
2. REAR BUSHING
1) Put an alignment mark on the front arm based on
the center of rear bushing recess portion.
CAUTION:
Always put an alignment mark for aligning the
position on bushing installation.
(1)
(1) Put an alignment mark.
(2) Recess section
Front Arm
ST
FS-00110
(1)
(2)
FS-00111
FS-20
2) Using the ST and a press, remove the rear bush-
ing.
ST1 20299AG000 REMOVER
ST2 20299AG010 BASE
(2)
(1) Press
(2) Front arm
(3) Rear bushing
D: ASSEMBLY
1. FRONT BUSHING
Assemble in the reverse order of disassembly.
2. REAR BUSHING
1) Install the rear bushing with its longer inner cyl-
inder facing upward and the shorter facing down-
ward and protruding part rearward as shown in the
figure.
(1)
(1) Front arm
(2) Bushing inner cylinder
(3) Longer
(4) Shorter
(5) Protrusion portion
(1)
ST1
ST2
(3)
FS-00126
(5)
(3)
(4)
(2)
FS-00113