Subaru 2009 IMPREZA Service Manual page 1846

AT Shift Lock Solenoid and "P" Range Switch
11) Using a flat tip screwdriver with a thin tip, dis-
connect the terminals of "P" range switch and shift
lock solenoid unit from the connector.
(A) "P" range switch terminal
(B) Shift lock solenoid terminal
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
• Refer to "COMPONENT" for each tightening
torque. <Ref. to CS-3, COMPONENT, General De-
scription.>
• When installing the plate guide COMPL, set the
select lever to the "D" range (normal mode posi-
tion), and be careful for the following points.
• Insert the protrusion (B) of the plate guide
COMPL into the hole on shift lock solenoid unit
(A).
• Insert link (D) of the shift lock release into link
(C) of the shift lock solenoid unit.
b
a
b
(D)
(C)
(B) (A)
4 3 2 1
10 9 8 7 6 5
CS-00309
a
(B)
(A)
CS-00952
CS-29
• Connect the switch and solenoid terminals to the
connector.
(B) (A)
(A) "P" range switch (color code: white)
(B) "P" range switch (color code: black)
(C) Shift lock solenoid (color code: blue/red)
(D) Shift lock solenoid (color code: black)
CONTROL SYSTEMS
(D) (C)
1 2 3 4
5 6 7 8 9 10
CS-00394