Intake Manifold; Removal - Isuzu 1999 RODEO Workshop Manual

6A–20 ENGINE MECHANICAL (X22SE 2.2L)

Removal

1. Disconnect battery ground cable.
2. Remove PCV hose from air intake duct.
3. Remove a nut from air intake duct bracket and loosen
hose clamp on throttle body. Remove air intake duct
assembly with air cleaner cover.
4. Drain engine coolant.
5. Remove water hoses from throttle body.
6. Disconnect the connector for throttle position sensor,
idle air control valve sensor from throttle body.
7. Remove fuel pipe joint eye bolts from fuel rail and
disconnect wire harness from fuel injector.
8. Disconnect hose from fuel pressure regulator then
remove fuel rail assembly.
9. Remove throttle valve control cable from throttle
body.
10. Remove fixing bolts for generator bracket.

Intake Manifold

11. Remove water pipe fixing bolt then remove water
pipe.
12. Remove fixing bolt from bracket (Between cylinder
block and intake manifold) of intake manifold side.
13. Remove ignition coil bracket fixing bolt.
14. Remove bolt and seven nuts, and remove intake
manifold.
042RW001
065RW025
025RW002
027RW002