Swc8532 - Dell PowerEdge VRTX Reference Manual

Detailed The Chassis Management Controller is unable to set the administrator role for the iDRAC root
Description user. This can happen if the communction to the iDRAC from CMC is non-functional or iDRAC is
rebooting.
Recommended If communications with the iDRAC is not functioning, reset the iDRAC and retry the operation
Response Action after a few minutes. Run the RACADM command "racadm ping server-<slot number> " to check
the communications. If the communications are not functional, restart the iDRAC by performing
a Virtual Reseat of the server using the RACADM command "racadm racreset -m server-<slot
id>".
Category Audit
SubCategory SWC = Software Config
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. LC Log
Filter IPMI Alert SNMP
Visibility Alert
FALSE FALSE FALSE

SWC8532

Message Chassis Management Controller is unable to set chassis assigned QuickDeploly IP addresses
because the starting IP address cannot accomodate all iDRACs.
Detailed The starting IP address specified cannot accommodate all the servers. The starting iDRAC IPv4
Description Address specifies the static IPv4 address of the iDRAC located in the first slot. The static IPv4
address of each subsequent iDRAC is calculated as a slot number increment of this IPv4
address.
Recommended Make sure there are enough IPv4 addresses for all the iDRACs and then retry the operation.
Response Action
Category Audit
SubCategory SWC = Software Config
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. LC Log
Filter IPMI Alert SNMP
Visibility Alert
FALSE FALSE FALSE
774
Email LC Log LCD
Alert
FALSE TRUE FALSE
Email LC Log LCD
Alert
FALSE TRUE FALSE
Power Off Power Reset
Cycle
FALSE FALSE FALSE
Power Off Power Reset
Cycle
FALSE FALSE FALSE