Enc6 - Dell PowerEdge VRTX Reference Manual

Dell poweredge vrtx chassis management controller firmware event message reference guide version 1.0

Hide thumbs Also See for PowerEdge VRTX:

Table of Contents

Identify and replace the failed component. To identify the failed component, select the

Response Action

enclosure in the tree view and click the Health subtab. Any failed component will be identified

with a red X on the enclosures Health subtab. Alternatively, you can select the Storage object

and click the Health subtab. The controller status displayed on the Health subtab indicates

whether a controller has a failed or degraded component. See the enclosure documentation

for information on replacing enclosure components and for other diagnostic information.

ENC6

Communication timeout on

The controller is unable to communicate with an enclosure. There are several reasons for

communication loss. For example, there may be a bad or loose cable. An unusual amount of I/O

may also interrupt communication with the enclosure. In addition, communication loss may be

caused by software, hardware, or firmware problems, bad or failed power supplies, and

enclosure shutdown.

Check for problems with the cables. See the Cables attached correctly section for more

Response Action

information on checking the cables. You should also check to see if the enclosure has

degraded or failed components. To do this, select the enclosure object in the tree view and

click the Health subtab. The Health subtab displays the status of the enclosure components.

Verify that the controller has the supported driver and firmware versions installed and that

each Enclosure Management Modules (EMMs) are running the same version of supported

Table of Contents