Address-Family; Aggregate-Address - Dell Force10 S4810P Reference Manual

address-family

Enable the IPv4 multicast or the IPv6 address family.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax address-family [ipv4 multicast| ipv6unicast]
Parameters
ipv4 multicast
ipv6 unicast
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 6.5.1.0

aggregate-address

Summarize a range of prefixes to minimize the number of entries in the routing table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax aggregate-address ip-address mask [advertise-map map-name] [as-
set] [attribute-map map-name] [summary-only] [suppress-map map-
name]
Parameters
ip-address mask
advertise-map
map-name
as-set
attribute-map
map-name
summary-only
352
Enter BGPv4 multicast mode.
Enter BGPv6 mode.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Enter the IP address and mask of the route to be the aggregate
address. Enter the IP address in dotted decimal format (A.B.C.D) and
mask in /prefix format (/x).
(OPTIONAL) Enter the keywords advertise-map followed by the
name of a configured route map to set filters for advertising an
aggregate route.
(OPTIONAL) Enter the keyword as-set to generate path attribute
information and include it in the aggregate.
AS_SET includes AS_PATH and community information from the
routes included in the aggregated route.
(OPTIONAL) Enter the keywords attribute-map followed by the
name of a configured route map to modify attributes of the aggregate,
excluding AS_PATH and NEXT_HOP attributes.
(OPTIONAL) Enter the keyword summary-only to advertise only
the aggregate address. Specific routes are not advertised.