Show Ip Interface - Dell Force10 S4810P Reference Manual

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 S4810P:

Table of Contents

Version 7.6.1.0

Version 7.5.1.0

This command provides egress port information for a given IP flow. This is useful in identifying

which interface the packet follows in the case of Port-channel and Equal Cost Multi Paths. Use

this command for routed packed only. For switched packets, use the show port-

channel-flow command.

The show ip flow command does not compute the egress port information when load-

balance mac hashing is also configured due to insufficient information (the egress MAC

is not available).

S-Series produces the following error message: %Error: Unable to read IP route

C-Series produces the message: %Error: FIB cannot compute the egress

port with the current trunk hash setting.

FTOS#show ip flow interface Gi 1/8 189.1.1.1 63.0.0.1 protocol

tcp source-port 7898 destination-port 8

flow: 189.1.1.1 63.0.0.1 protocol 6 7868 8976

Ingress interface:Gi 1/20

Egress interface:Gi 1/14 to 1.7.1.2[CAM hit 103710]

unfragmented packet

show ip interface

View IP-related information on all interfaces.

C-Series, E-Series, S-Series, Z-Series, S4810

show ip interface [interface | brief | linecard slot-number]

[configuration]

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

Gi 1/10 to 1.2.1.2[CAM hit 103710] fragmented

(OPTIONAL) Enter the following keywords and slot/port or number

information:

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For a Loopback interface, enter the keyword Loopback

followed by a number from 0 to 16383.

For the Management interface, enter the keyword

ManagementEthernet followed by zero (0).

For the Null interface, enter the keyword null followed by