Network - Dell Force10 S4810P Reference Manual

weight
Defaults 0
Command Modes ROUTER BGP
Command History
Version 8.2.1.0
Version 7.4.1.0
Usage In the FTOS best path selection process, the path with the highest weight value is preferred.
Information

network

Specify the networks for the BGP process and enter them in the BGP routing table.
C-Series, E-Series
Syntax network ipv6-address prefix-length [route-map map-name]
To remove a network, use the no network ip-address mask [route-map map-
name] command.
Parameters
ipv6-address
prefix-length
mask
route-map
name
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
520
Enter a number as the weight. The range is 0 to 65535. The default is
0.
Introduced on the E-Series ExaScale.
Introduced
NOTE: Reset the neighbor connection (the clear ip bgp * command) to apply the
weight to the connection and recompute the best path.
Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Enter the mask of the IP address in the slash prefix length format (for
example, /24). The mask appears in command outputs in dotted
decimal format (A.B.C.D).
map-
(OPTIONAL) Enter the keywords
an established route map. Only the following ROUTE-MAP mode
commands are supported:
•
•
•
•
If the route map is not configured, the default is deny (to drop all
routes).
route-map followed by the name of
match ipv6 address
match ipv6 next-hop
match ipv6 route-source
set ipv6 next-hop