Default-Vlan Disable; Enable Vlan-Counters - Dell Force10 S4810P Reference Manual

pre-Version
6.2.1.1
Usage
To return VLAN 1 as the Default VLAN, use this command syntax (default-vlan-id 1).
Information
The Default VLAN contains only untagged interfaces.
Related interface vlan
Commands

default-vlan disable

Disable the default VLAN so that all switchports are placed in the Null VLAN until they are explicitly configured as a
member of another VLAN.
C-Series, E-Series, S-Series, Z-Series, S4810
Defaults Enabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Usage no default vlan disable is not listed in the running-configuration, but when the
Information
default VLAN is disabled, default-vlan disable is listed in the running-configuration.

enable vlan-counters

Display VLAN counters for ingress and/or egress hardware. You must be in restricted mode to use this command.
E-Series ExaScale
Syntax enable vlan-output-counters [ingress | egress | all]
To return to the default (disabled), use the no enable vlan-output-counters
command.
Defaults Disabled — VLAN counters are disabled in hardware (all linecards/port-pipes) by default.
Command Modes CONFIGURATION
Command History
Version 8.1.1.2
Version 8.1.1.0
Usage
FTOS supports a command to enable viewing of the VLAN input/output counters. This
Information
command also applies to SNMP requests. If the command is not enabled, IFM returns zero
values for VLAN output counters.
1050
Introduced on the E-Series.
– configures a VLAN.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Introduced on the E-Series ExaScale E600i.
Introduced on the E-Series ExaScale E1200i.