Ipv6 Nd Suppress-Ra; Ipv6 Neighbor - Dell Force10 S4810P Reference Manual

Parameters
milliseconds
Defaults 3600000 milliseconds
Command Modes INTERFACE
Usage
The description of reachable time from RFC 2461 (http:// tools.ietf.org/html/rfc2461) is:
Information
Reachable Time: 32-bit unsigned integer. The time, in milliseconds, that a node assumes a
neighbor is reachable after having received a reachability confirmation. Used by the Neighbor
Unreachability Detection algorithm. A value of zero means unspecified (by this router).

ipv6 nd suppress-ra

Suppress the IPv6 router advertisement transmissions on an interface.
E-Series
Syntax ipv6 nd suppress-ra
To enable the sending of IPv6 router advertisement transmissions on an interface, use the no
ipv6 nd suppress-ra command.
Defaults Enabled.
Command Modes INTERFACE

ipv6 neighbor

Configure a static entry in the IPv6 neighbor discovery.
E-Series, S4810
Syntax ipv6 neighbor {ipv6-address} {interface interface}
{hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6
neighbor {ipv6-address} {interface interface} command.
Parameters
ipv6-address
interface
interface
1138
Enter the reachability time in milliseconds. The range is 0 to 3600000.
Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zero.
Enter the keyword interface followed by the interface type and
slot/port or number information: