Dell Force10 S4810P Reference Manual page 864

mac {dest-mac |
source-dest-mac
| source-mac}
tcp-udp enable
ingress-port
enable
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.10.0
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Usage By default, FTOS distributes incoming traffic based on a hash algorithm using the following
Information criteria:
Related hash-algorithm ecmp
Commands
864
Enter the keywords to distribute MAC traffic based on the following
criteria:
•
•
•
Enter the keywords to distribute traffic based on the following:
•
Enter the keywords to distribute traffic based on the following:
•
Introduced on the Z9000.
Added the ingress-port parameter for the S4810.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
• IP source address
• IP destination address
• TCP/UDP source port
• TCP/UDP destination port
– changes the hash algorithm across an ECMP.
dest-mac — Uses the destination MAC address, VLAN,
Ethertype, source module ID and source port ID fields to
hash. The hashing mechanism returns a 3-bit index indicating
which port the packet should be forwarded.
source-dest-mac — Uses the destination and source
MAC address, VLAN, Ethertype, source module ID and source
port ID fields to hash. The hashing mechanism returns a 3-bit
index indicating which port the packet should be forwarded.
source-mac — Uses the source MAC address, VLAN,
Ethertype, source module ID and source port ID fields to
hash. The hashing mechanism returns a 3-bit index indicating
which port the packet should be forwarded.
enable — Takes the TCP/UDP source and destination ports
into consideration when doing hash computations. (By
default, this is enabled.)
enable — Takes the source port into consideration when
doing hash computations. (By default, this is disabled.)