Maximum-Paths - Dell Force10 S4810P Reference Manual

To restore the default time, use the no max-lsp-lifetime command.
Parameters
seconds
Defaults 1200 seconds
Command Modes ROUTER ISIS
Command History
Version 8.3.12.0
Usage
Change the maximum LSP lifetime with this command. The maximum LSP lifetime must always
Information
be greater than the LSP refresh interval.
The seconds parameter enables the router to keep LSPs for the specified length of time. If
the value is higher, the overhead is reduced on slower-speed links.
Related lsp-refresh-interval
Commands

maximum-paths

Allows you to configure the maximum number of equal cost paths allowed in a routing table.
E-Series, S4810
Syntax maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
number
Defaults 4
Command Modes
Command History
Version 8.3.12.0
Version 7.8.1.0
Version 6.3.1.0
998
The maximum lifetime of LSP in seconds. This value must be greater
than the lsp-refresh-interval command. The higher the
value the longer the LSPs are kept. The range is 1 to 65535. The
default is 1200.
Introduced on the S4810.
– use this command to set the link-state packet (LSP) refresh interval.
Enter a number as the maximum number of parallel paths an IP
routing installs in a routing table. The range is 1 to 16. The default is 4.
for IPv4 )
• ROUTER ISIS (
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (
Introduced on the S4810.
Added support for multi-topology ISIS.
Introduced.
for IPv6 )