Redistribute - Dell Force10 S4810P Reference Manual

To remove a network, use the no network ip-address mask [route-map map-
name] command.
Parameters
ip-address
mask
route-map
name
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0
Version 7.7.1.0
Version 7.6.1.0
Usage FTOS software resolves the network address configured by the network command with the
Information
routes in the main routing table to ensure that the networks are reachable using non-BGP
routes and non-default routes.
Related

redistribute

Commands
redistribute
Redistribute routes into BGP.
C-Series, E-Series TeraScale, S-Series
Syntax redistribute [connected | static] [route-map map-name]
To disable redistribution, use the no redistribution [connected | static]
[route-map map-name] command.
Enter an IP address in dotted decimal format of the network.
Enter the mask of the IP address in the slash prefix length format (for
example, /24).
The mask appears in command outputs in dotted decimal format
(A.B.C.D).
map-
(OPTIONAL) Enter the keyword route-map followed by the name of
an established route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all
routes).
Introduced on the S-Series.
Introduced on the C-Series.
Introduced IPv6 MGBP on the E-Series.
– redistributes routes into the BGP.
453