Ip Community-List - Dell Force10 S4810P Reference Manual

Defaults Not configured.
Command Modes COMMUNITY-LIST
Usage The regular expression must match part of the ASCII-text in the AS-PATH attribute of the BGP
Information route.
Command History
Version 8.1.1.0
pre-Version
6.1.1.0

ip community-list

Enter COMMUNITY-LIST mode and create an IP community-list for BGP.
E-Series, S4810
Syntax ip community-list comm-list-name
To delete a community-list, use the no ip community-list comm-list-name
command.
Parameters
comm-list-name
Command Modes CONFIGURATION
Command History
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
pre-Version
6.1.1.0
Example
FTOS(conf)#ip community-list TestComList
FTOS(config-community-list)#
330
NOTE: You must enter an escape sequence (CNTL+v)
prior to entering the ? regular expression.
• [ ] = (brackets) matches a range of single-character
patterns.
• ^ = (caret) matches the beginning of the input string. (If you
use the caret at the beginning of a sequence or range, it
matches on everything BUT the characters specified.)
• $ = (dollar sign) matches the end of the output string.
• _ = (underscore) matches a comma (,), left brace ({), right
brace (}), left parenthesis, right parenthesis, the beginning of
the input string, the end of the input string, or a space.
• | = (pipe) matches either character.
Introduced on the E-Series ExaScale.
Introduced on the E-Series.
Enter a text string as the name of the community-list, up to 140
characters.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
Introduced on the E-Series.